Unit 3 — Assembly and Setup

TM-TOOL-003 — Open Handout TM Chapter: Chapter 4 ELOs: Execute assembly steps in the correct sequence; verify build quality before operation Estimated time: 20 minutes

Step 1: Read the TM

Open TM-TOOL-003. Read Chapter 4 — Construction and Assembly completely.

Then come back here.

Chapter 4 Content

4-1 Dipole Example

from nec_generator import Dipole, NECModel ant = Dipole(freq_mhz=14.25, height_m=10.0) model = ant.to_nec_model() model.write("dipole_20m.nec") This generates a half-wave dipole resonant at 14.25 MHz, 10 m above real ground (εr=13, σ=0.005 S/m). The GW card for each half-element uses recommended_segments() to set segment count automatically.

4-2 Vertical with Radials from nec_generator import VerticalWithRadials ant = VerticalWithRadials(freq_mhz=7.1, n_radials=32, radial_length_m=10.0, height_m=0.1) model = ant.to_nec_model() model.write("vertical_40m.nec") 4-3 Frequency Sweep from freq_sweep import FrequencySweep sweep = FrequencySweep(model, start_mhz=1.8, stop_mhz=30.0, n_steps=200) results = sweep.run() sweep.plot_impedance(results) sweep.plot_swr(results, z0=50.0)

Assembly Quality

Work through all construction steps in Chapter 4 in sequence.

The assembly directly determines measurement quality. Common errors: - RF leads too long — lead inductance raises SWR and limits high-frequency performance - Cold solder joints on RF nodes — high resistance causes signal loss and intermittent readings - Ground loops — multiple ground paths at different potentials cause noise and calibration errors - Ferrite winding errors — wrong turn count or direction reverses transformer polarity

If Chapter 4 specifies a verification step after assembly (e.g., "verify DC resistance = X before proceeding"), do it. Those checks exist because they are the most common failure points.

Self-Check Questions

SC3-1. How many assembly steps does Chapter 4 specify?

SC3-2. What is the first assembly step? State it exactly from the TM.

SC3-3. Does Chapter 4 specify maximum lead length anywhere? If so, what is the limit and why?

SC3-4. Does Chapter 4 require a bench verification after assembly? What does it check?

SC3-5. What would you do if a winding resistance measurement came out wrong during assembly verification?

Answer Key

SC3-1. Count the numbered steps in Chapter 4.

SC3-2. See Chapter 4, step 1. Copy it exactly.

SC3-3. RF lead length limits are typically 10–15 mm for HF circuits. Longer leads add ~1–2 nH per mm, raising inductive reactance at high frequencies.

SC3-4. Scan Chapter 4 for verification steps. Common checks: DC resistance, winding balance, null depth on test signal.

SC3-5. Stop assembly. Diagnose before proceeding — a winding error found before completion is much easier to fix than one discovered after the unit is boxed.

Checkpoint

Before proceeding: - [ ] You have read Chapter 4 completely - [ ] You can state the number of assembly steps and the first and last steps - [ ] You understand how assembly quality affects measurement accuracy

→ Proceed to Unit 4